HelpDesk SKM Software Help Desk
sign in
Knowledge base Ideas forum

  • Sales
  • General Sales
  • Library Model Request
  • General Library Question
  • Technical Support
  • General Support
  • Oneline & User Interface
  • License Key Issues
  • Downloading/Installing Software
  • Printing
  • Reports
  • Equipment Modeling
  • DAPPER (Demand Load)
  • DAPPER (Load Flow)
  • DAPPER (Short Circuit)
  • CAPTOR (TCC)
  • Arc Flash Evaluation
  • Equipment Evaluation
  • Cable Ampacity
  • A_Fault (ANSI)
  • IEC 60909 Fault
  • IEC 61363 Fault
  • TMS (Transient Motor Starting)
  • HI_WAVE (Harmonics)
  • Unbalanced/Single Phase
  • DC Systems Analysis
  • GroundMat
  • Cable-3D
  • Scenario Manager
  • Backup & Import/Export

DAPPER (Short Circuit)

  • ↑↓ SLG Fault current flowing back to Primary of the transformer with no load

    Tuesday, September 8, 2020 slg primary transformer no load secondary

  • ↑↓ Current Limiting Protective Devices and its effects on Fault Calculations

  • ↑↓ Why is the calculated SLG fault higher than the calculated 3phase fault?

  • ↑↓ The generator manufacturer says my generator will only put out so much SLG fault current (8.3kA) but PTW calculates a much higher SLG current, why?

  • ↑↓ SLG Current Calculations

    Updated: Wednesday, February 15, 2017

  • ↑↓ Why am I seeing small SLG values?

    slg small display vlaue

  • ↑↓ Utility Line to Ground X/R (Calculated Equation)

  • ↑↓ Which transformer connection types does not produce SLG fault current?

  • ↑↓ Datablock for Thevenin equivalent X and R value

  • ↑↓ Differences between SLG & SLG Neutral Currents for Transformers & Generators

    Updated: Friday, November 13, 2020

  • ↑↓ How is the neutral impedance obtained for transformers/generators based on the neutral current limit?

Get help for this page Powered by Jitbit HelpDesk