HelpDesk SKM Software Help Desk

  • Sales
    • General Sales
  • Library Model Request
    • General Library Question
  • Technical Support
    • General Support
    • Oneline & User Interface
    • License Key Issues
    • Downloading/Installing Software
    • Printing
    • Reports
    • Equipment Modeling
    • DAPPER (Demand Load)
    • DAPPER (Load Flow)
    • DAPPER (Short Circuit)
    • CAPTOR (TCC)
    • Arc Flash Evaluation
    • Equipment Evaluation
    • Cable Ampacity
    • A_Fault (ANSI)
    • IEC 60909 Fault
    • IEC 61363 Fault
    • TMS (Transient Motor Starting)
    • HI_WAVE (Harmonics)
    • Unbalanced/Single Phase
    • DC Systems Analysis
    • GroundMat
    • Cable-3D
    • Scenario Manager
    • Backup & Import/Export

DAPPER (Load Flow)

  • Parallel Utilities not evenly shared in Load Flow
    Updated: Wednesday, July 13, 2016
  • Why is the PF very low in running the Demand Load Study when a Capacitor is added to the system?
  • Initial Voltage for Utility or Swing Bus Generator in Short Circuit Study
  • Initial Voltage for Utility or Swing Bus Generator for Load Flow Study
  • How do I resolve a diverging Solution in the load flow study?
  • If I’m running a LF study (motor impact starting) and my sources are all generators (defined as SB), what source impedance is the LF study options dialog referring too?
  • How is the induction motor startup current multiplication factor calculated in a load flow study?
  • How do I calculate voltage drop across transformer?
  • How do I calculate voltage drop across cable?
  • How do I model a reduced voltage starter when performing an Impact Motor Starting study using the Load Flow?
  • How is the induction motor startup current multiplication factor calculated?
  • VFD Rated Current is less than its loading
get help Get help for this page
Powered by Jitbit Helpdesk Logo Jitbit HelpDesk