- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
What is the difference between the time multiplier and time adder setting on relays under the "Selected Device Settings" and the "Adder Shifter Test Points"?
Answer: The time adder and multiplier adjustments done on the "Selected Device Settings" will only affect the curve on the TCC plot.
If adjusted in the "Adder Shifter Test Points" it will affect both the curve and the Arc Flash trip delay time reporting.
If adjusted in the "Adder Shifter Test Points" it will affect both the curve and the Arc Flash trip delay time reporting.