- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Is DC Arc Flash in v7.0 included in 2012 NFPA 70E?
DC Arc Flash is included in the 2012 NFPA 70E under Annex D.8. It is implemented in PTW V7.0 using the Maximum Power Method (D.8.1.1). This method is based on the IEEE paper, "Arc Flash Calculations for Exposures to DC Systems" authored by Daniel R. Doan.
Get help for this page
Jitbit HelpDesk