- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
How do I make the PPE table in Arc Flash project specific?
By default the miscellaneous directory points to C:\PTW32\Lib. You can create your own miscellaneous folder and place it inside your project folder to make it project specific.
To do this you can copy the Lib folder in C:\PTW32\Lib and paste it to any location. To save space, you may delete both library files (ptw.lib and changes.lib), the RPTFMT and any default folders from this new directory.
Then you can follow the steps below to set the new directory. Point the Directory field to your new location.

To do this you can copy the Lib folder in C:\PTW32\Lib and paste it to any location. To save space, you may delete both library files (ptw.lib and changes.lib), the RPTFMT and any default folders from this new directory.
Then you can follow the steps below to set the new directory. Point the Directory field to your new location.