- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Where do I define Glove Class in for my Arc Flash study?
Answer: The Glove Class Table can be defined by going to Arc Flash Evaluation > Study Options > Report Options
Glove Class is based on the voltage level. The below Glove Class table comes from ASTM D 120-95.
Glove Class is based on the voltage level. The below Glove Class table comes from ASTM D 120-95.