- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Loading System Data Doesn't go away when using PTW
1) Open PTW then go to Project > start up > select “Start with empty workspace” then click ok.
2) Exit out of program
3) Go to start > type “\PTW32\bin”
4) Run RegDel.exe > select all setting > ok
5) Once the registry clean up, run the PTW program.
2) Exit out of program
3) Go to start > type “\PTW32\bin”
4) Run RegDel.exe > select all setting > ok
5) Once the registry clean up, run the PTW program.