HelpDesk SKM Software Help Desk
sign in
Knowledge base Ideas forum

  • Sales
  • General Sales
  • Library Model Request
  • General Library Question
  • Technical Support
  • General Support
  • Oneline & User Interface
  • License Key Issues
  • Downloading/Installing Software
  • Printing
  • Reports
  • Equipment Modeling
  • DAPPER (Demand Load)
  • DAPPER (Load Flow)
  • DAPPER (Short Circuit)
  • CAPTOR (TCC)
  • Arc Flash Evaluation
  • Equipment Evaluation
  • Cable Ampacity
  • A_Fault (ANSI)
  • IEC 60909 Fault
  • IEC 61363 Fault
  • TMS (Transient Motor Starting)
  • HI_WAVE (Harmonics)
  • Unbalanced/Single Phase
  • DC Systems Analysis
  • GroundMat
  • Cable-3D
  • Scenario Manager
  • Backup & Import/Export

Calculation of current at time T0

Print...
Where can the user enter the value for T0?

T0 is an internal time parameter which is always 5 cycles (0.1sec) and cannot be defined by the user unlike T1-T4 in IEC 61363.
image001.png

On this page

    Get help for this page Powered by Jitbit HelpDesk