- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Everytime I open or save TCC, PTW run study in the background (Solution)
Every time I open or save a TCC, or make a change to a TCC, PTW runs through a fault study. Since this project has multiple scenarios, this is very time-consuming. I thought there was a way to turn that feature off, but I am not finding it.
Solution:
Perhaps you have the Arc Flash window open in the background. Go to Windows->Cascade to see which windows are open. If AF is open, close it or you can go to its study options and uncheck "Auto update Arc Flash results".
Solution:
Perhaps you have the Arc Flash window open in the background. Go to Windows->Cascade to see which windows are open. If AF is open, close it or you can go to its study options and uncheck "Auto update Arc Flash results".