- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Form Print does not take up entire One-line Area
User is trying to print to a 22x34 sheet. The one-line is not taking up the entire One-Line Area of the Form. See below:
Smaller paper size Forms fit the One-Line area much better. A work around is to use a smaller Form (8.5x 11 in for example) but in the Print Setup, select the actual paper size ( in this case 22x36 in). In the Advanced setting, you can also increase the scaling percentage.
Files | ||
---|---|---|
DataImage54.png 806 KB |
||
DataImage90.png 262 KB |