- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
SKM with Brady Printer IP300 (Printing Instruction)
1) Install latest Brady printer driver from Brady’s website. As of this writing, the latest driver is dated Dec 2013.
https://www.bradyid.com/downloads?filename=Direct_Thermal_Printer_Driver_Dec2013.zip

2) Make sure appropriate label is selected. For 4”x4” label, use:
_SKM_Risk_Label_Sample 11 - Brady THTEL-161-483-1-DA/WA, R6007 Ribbon(4x4)

3) Make label selection:

4) Make Printer Property Changes:

https://www.bradyid.com/downloads?filename=Direct_Thermal_Printer_Driver_Dec2013.zip
2) Make sure appropriate label is selected. For 4”x4” label, use:
_SKM_Risk_Label_Sample 11 - Brady THTEL-161-483-1-DA/WA, R6007 Ribbon(4x4)
3) Make label selection:
4) Make Printer Property Changes: