- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Cable Ampacity - Triplexed Cables
Problem:
For library “ Directly Buried Cable – Detail 8 or Detail 7 “ . These should be triplexed cables, I’m not sure why they show up as not being in a triplex form but rather just side by side?
Solution:
Per R&D,
We use equilateral configuration and it is a little more conservative and is on the safety side.
For library “ Directly Buried Cable – Detail 8 or Detail 7 “ . These should be triplexed cables, I’m not sure why they show up as not being in a triplex form but rather just side by side?
Solution:
Per R&D,
We use equilateral configuration and it is a little more conservative and is on the safety side.