- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
How can I copy components from a oneline drawing to another oneline drawing?
Question: I've merged two projects which has created two separate single lines in the project that was merged. How can I copy components from a oneline drawing to another oneline drawing?
Answer: You may use the COPY and PASTE command to do this. Highlight the entire oneline and press Ctrl+C to copy. Then open the other oneline and press Ctrl +V command to paste it.
Answer: You may use the COPY and PASTE command to do this. Highlight the entire oneline and press Ctrl+C to copy. Then open the other oneline and press Ctrl +V command to paste it.