- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
Component Editor does not update (Solution) - Incorrect display
Question:
When I double click on a component in One-line, it does not update the component editor to show this device. Even with "Go to component editor" does not work.
It works fine on other computers. Why?
Solution:
First, check if user have read/write access on the location where the project is located.
Second, double click on a component, go to Window and see if Component Editor is listed... If it is listed, click on Cascade
This command bring all the windows to the top (Including the one off screen).
When I double click on a component in One-line, it does not update the component editor to show this device. Even with "Go to component editor" does not work.
It works fine on other computers. Why?
Solution:
First, check if user have read/write access on the location where the project is located.
Second, double click on a component, go to Window and see if Component Editor is listed... If it is listed, click on Cascade
This command bring all the windows to the top (Including the one off screen).