- General Support
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Printing
- Reports
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- GroundMat
- Cable-3D
- Scenario Manager
- Backup & Import/Export
DAPPER (Short Circuit)
-
SLG Fault current flowing back to Primary of the transformer with no load
Tuesday, September 8, 2020 slg primary transformer no load secondary
-
Current Limiting Protective Devices and its effects on Fault Calculations
-
Why is the calculated SLG fault higher than the calculated 3phase fault?
-
The generator manufacturer says my generator will only put out so much SLG fault current (8.3kA) but PTW calculates a much higher SLG current, why?
-
SLG Current Calculations
Updated: Wednesday, February 15, 2017
-
Why am I seeing small SLG values?
slg small display vlaue
-
Utility Line to Ground X/R (Calculated Equation)
-
Which transformer connection types does not produce SLG fault current?
-
Datablock for Thevenin equivalent X and R value
-
Differences between SLG & SLG Neutral Currents for Transformers & Generators
Updated: Friday, November 13, 2020
-
How is the neutral impedance obtained for transformers/generators based on the neutral current limit?