- General Support Question
- Oneline & User Interface
- License Key Issues
- Downloading/Installing Software
- Equipment Modeling
- DAPPER (Demand Load)
- DAPPER (Load Flow)
- DAPPER (Short Circuit)
- CAPTOR (TCC)
- Arc Flash Evaluation
- Equipment Evaluation
- Cable Ampacity
- A_Fault (ANSI)
- IEC 60909 Fault
- IEC 61363 Fault
- TMS (Transient Motor Starting)
- HI_WAVE (Harmonics)
- Unbalanced/Single Phase
- DC Systems Analysis
- Scenario Manager
- Backup & Import/Export
DAPPER (Load Flow)
Parallel Utilities not evenly shared in Load Flow
Updated: Wednesday, July 13, 2016
Why is the PF very low in running the Demand Load Study when a Capacitor is added to the system?
Initial Voltage for Utility or Swing Bus Generator in Short Circuit Study
Initial Voltage for Utility or Swing Bus Generator for Load Flow Study
How do I resolve a diverging Solution in the load flow study?
If I’m running a LF study (motor impact starting) and my sources are all generators (defined as SB), what source impedance is the LF study options dialog referring too?
How is the induction motor startup current multiplication factor calculated in a load flow study?
How do I calculate voltage drop across transformer?
How do I calculate voltage drop across cable?
How do I model a reduced voltage starter when performing an Impact Motor Starting study using the Load Flow?
How is the induction motor startup current multiplication factor calculated?
VFD Rated Current is less than its loading